To obtain your registration ID "Invitation Code", please send your request to: [email protected]


ITCDiag
OBD2 Buy, OBD2, OBDII, OBD, car diagnostic, truck scanner, workshop, Chip tuning, fault code reader, IMMO
obdresource
xcar360

DiagPro3

 
Donate and Help Forum

After DONATION send EMAIL to ADMINSTRATOR HERE.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
BMW DDE 7 Ecu Swap ?
#1
BMW 
i have a water damaged Ecu from BMW 1 Series Diesel and need to replace it with a used one i have read that u can virgin the eeprom in ecu and do alignment i am not so sure about this on older bmw i just used to swap the eeprom
Bosch
DDE 7798180
0281012501
i want to know where is the ISN in the ecu
will it be ok just to swap the eeprom and align the CAS or is there more to this ?
i do not work a lot on BMW so i do not have all the fancy ICOM and ISTA
Reply
Thanks given by:
#2
read full bdm and write to new wcu
[Image: 2gy4oax.jpg]
Reply
Thanks given by: jakesvw
#3
so if i take used ecu and put eeprom from old ecu then inpa can sync the cas ? but i do not think used ecu will sync like it is maybe if i virgin the eeprom or swap it
Reply
Thanks given by:
#4
(10-27-2016, 07:11 PM)jakesvw Wrote:  so if i take used ecu and put eeprom from old ecu then inpa can sync the cas ? but i do not think used ecu will sync like it is maybe if i virgin the eeprom  or swap it

INPA DIAGNOSTIC TOOL . CAS-DDE SINXRO ALL OK
[Image: 2gy4oax.jpg]
Reply
Thanks given by: Administrator , jakesvw
#5
mail the EPROM files friend'll syncro
Reply
Thanks given by: Administrator , jakesvw


Forum Jump:


Users browsing this thread: 1 Guest(s)